User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-84
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
--> pppoe set transport pppoe1 givedns client enabled
See also PPPOE SET TRANSPORT GIVEDNS RELAY ENABLED|DISABLED
PPPOE SET TRANSPORT REMOTEDNS
PPPOE SET TRANSPORT DISCOVERDNS PRIMARY
PPPOE SET TRANSPORT DISCOVERDNS SECONDARY
8.7.4.1.20 PPPOE SET TRANSPORT GIVEDNS RELAY ENABLED|DISABLED
Syntax PPPOE SET TRANSPORT
{<name>|<number>} GIVEDNS RELAY {ENABLED |
DISABLED}
Description This command controls whether the PPP Internet Protocol Control Protocol (IPCP) can
request the DNS server IP address for a remote PPP peer. Once IPCP has discovered the
DNS server IP address, it automatically gives the address to the local DNS relay so that a
connection can be established.
You must have the DNS relay process included in your image build in order to use this
protocol.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
enabled IPCP can request a DNS server IP address and then give
the address to DNS client.
enabled
disabled IPCP cannot request a DNS server IP address and then
give the address to DNS client.