User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-78
Description This command specifies whether a route is added to the system after IPCP (Internet Pro-
tocol Control Protocol) negotiation is completed. If set to enabled, a route will be created
which directs packets to the remote end of the PPP link.
This route can either be a default route or a specific route, depending on the value set
using the pppoe set transport specificroute command.
To display the createroute setting, use the PPPOE SHOW TRANSPORT command. The
route is removed when the PPP link is disconnected.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 createroute disabled
Syntax PPPOE SHOW TRANSPORT PPPOE SET TRANSPORT SPECIFICROUTE IP
LIST ROUTES
8.7.4.1.12 PPPOE SET TRANSPORT DIALOUT
Syntax PPPOE SET TRANSPORT {<name>|<number>} DIALOUT
Description This command sets a PPPoE transport to perform dialout over a PVC (Permanent Virtual
Circuit). This replaces the transports existing dialin/dialout setting. The transport uses the
interface that was specified when the transport was created.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoE transport. To display transport names, use
the PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport numbers,
use the PPPOE LIST TRANSPORTS command.
N/A
enabled Adds a route to the system after IPCP negotiation. enabled
disabled Does not add a route to the system after IPCP negotiation.
Option Description Default Value
name An existing PPPoE transport. To display transport names, use
the pppoe list transports command.
N/A