User guide

PPPoE command reference PPPoE
8-77
iMG/RG Software Reference Manual (ADSL Port)
Example --> pppoe set transport pppoe1 bt 5
See also PPPOE SET TRANSPORT MBS
8.7.4.1.10 PPPOE SET TRANSPORT CONNECTNOW
Syntax PPPOE SET TRANSPORT
{<name>|<number>} CONNECTNOW {ENABLED|DIS-
ABLED}
Description This command is used to send a manual connectio request to the specified PPPoE trans-
port through CLI. The “manualconnect” option should be “enabled” before enabling con-
nectnow.
When disabled, this command tears down the specified PPPoE connection.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 connectnow enabled
Syntax PPPOE SHOW TRANSPORT
PPPOE SET TRANSPORT MANUALCONNECT
8.7.4.1.11 PPPOE SET TRANSPORT CREATEROUTE
Syntax PPPOE SET TRANSPORT
{<name>|<number>} CREATEROUTE {ENABLED|DIS-
ABLED}
burst tolerance Controls the duration of traffic bursts on VBR (Vari-
able Bit Rate) and VBR RT (VBR Real Time) channels.
This value overrides an existing MBS value (if set).
The BT can be any value between 0 and 100.
0
Option Description Default Value
name An existing PPPoE transport. To display transport names, use
the
PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport numbers, use
the
PPPOE LIST TRANSPORTS command.
N/A
enabled Gives manual connection request when “manualconnect” is
enabled.
enabled
disabled Gives a manual disconnect request.