User guide

PPPoE command reference PPPoE
8-75
iMG/RG Software Reference Manual (ADSL Port)
Description This command allows you to enable/disable the PPPoE autoconnect function. If enabled,
PPPoE automatically connects to TCP/IP whenever a user requests TCP/IP packets from a
public destination.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 autoconnect enabled
See also PPPOE LIST TRANSPORTS
PPPOE SET TRANSPORT AUTOCONNECT FILTER
8.7.4.1.8 PPPOE SET TRANSPORT AUTOCONNECT FILTER
Syntax PPPOE SET TRANSPORT {<name>|<number>} AUTOCONNECT FILTER
{ADD|DELETE} {TCPPORT <tcpportadd>|UDPPORT <udpportadd>}
Description This command allows you to add filters to TCP/UDP ports to prevent PPP from auto-
connecting with certain IP packets.
• Certain IP packet types may force an unwanted autoconnect sequence. Setting a fil-
ter on the port used by these packets prevents them from starting PPP autoconnect.
• The delete option allows you to clear an existing autoconnect filter.
Note: This command is only effective if you have already enabled PPP autoconnection using PPPOE
SET TRANSPORT AUTOCONNECT
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the pppoe list transports command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the pppoe list transports command.
N/A
enabled Enables PPPoE autoconnect. disabled
disabled Disables PPPoE autoconnect.