User guide

PPPoE command reference PPPoE
8-71
iMG/RG Software Reference Manual (ADSL Port)
Example --> pppoe add transport pppoe_t dialout eth 2 vlan_2
See also PPPOE LIST TRANSPORTS
IP LIST INTERFACES
VLAN SHOW
8.7.4.1.2 PPPOE ADD TRANSPORT DIALOUT PVC
Syntax PPPOE ADD TRANSPORT
<name> DIALOUT PVC <interface> <port> <vpi>
<vci> [
ACCESSCONCENTRATOR <concentrator>] [ SERVICENAME <service-
name>]
Description This command creates a PPPoE transport that performs dialout over a PVC (Permanent
Virtual Circuit). It allows you to specify the following PVC information:
• The PPP interface to the channel that the PVC will use
• The ATM port that will transport data
• VPI (Virtual Path Identifier)
• VCI (Virtual Circuit Identifier)
• Access concentrator (optional)
• Service name (optional)
The port/VPI/VCI combination must be unique for each transport.
OptionsThe following table gives the range of values for each option that can be specified
with this command and a default value (if applicable).
service name A PPPoE tag that identifies a specific service that is acceptable to
the PPPoE client. If set, the PPPoE transport will connect to the
first access concentrator it finds that uses this service. If an access
concentrator is also set, the PPPoE transport will connect to the
specified service on the named concentrator. It is your ISP that
determines the service name.
N/A
Option Description Default Value
name An arbitrary name that identifies the transport. It can
be made up of one or more letters or a combination of
letters and digits, but it cannot start with a digit.
N/A