User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-70
8.7.4.1.1 PPPOE ADD TRANSPORT DIALOUT ETH
Syntax PPPOE ADD TRANSPORT <name> DIALOUT ETH <interface>
<vlan_name> [ACCESSCONCENTRATOR <concentrator>] [SERVICENAME
<servicename>]
Description This command creates a PPPoE transport that performs dialout over a VLAN. It allows
you to specify the following PVC information:
• The VLAN name that will transport data
• Access concentrator (optional)
• Service name (optional)
OptionsThe following table gives the range of values for each option that can be speci-
fied with this command and a default value (if applicable).
PPPOE SET TRANSPORT THEYLOGIN XXXXX X X X X
PPPOE SET TRANSPORT USERNAME XXXXX X X X X
PPPOE SET TRANSPORT WELOGIN XXXXX X X X X
PPPOE SHOW TRANSPORT XXXXX X X X X
Option Description Default Value
Name An arbitrary name that identifies the transport. It can be
made up of one or more letters or a combination of let-
ters and digits, but it cannot start with a digit.
N/A
Interface The PPP interface to a channel that transports PPPoE data.
The interface value must be the ID value of the IP interface
that will be attached to the PPPoE transport. The IP ID
value is reported by the command
ip list interfaces.
N/A
vlan_name The vlan name that will be used to transport PPPoE
frames.
N/A
concentrator A PPPoE tag that identifies a remote access concentrator
(or PPPoE server). PPPoE will only connect to the named
access concentrator. If no concentrator tag is set, PPPoE
connects to the first access concentrator that responds. It
is your ISP that determines the tag name/number.
N/A
Functions
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E
Modular
ADSL
A
ADSL
B
ADSL
C