User guide

Emergency Emergency command reference
iMG/RG Software Reference Manual (System Configuration)
1-52
Option Description Default Value
Example emergency delete vlan 2 port lan4
emergency delete vlan 2
See also EMERGENCY ADD
EMERGENCY SHOW
EMERGENCY UPDATE
1.3.4.1.4 EMERGENCY SET DHCP
Syntax Syntax EMERGENCY SET DHCP { ENABLE | DISABLE }
Description This command is used to set the ip interface address used when the system runs in
recovery mode to be dynamic or static. If the interface is set statically and no ipaddress
is set with the command EMERGENCY SET IPINTERFACE command, the recovery
default ip address 192.168.1.1/24 will be used.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example emergency set dhcp enable
See also EMERGENCY SET IPINTERFACE IPADDRESS
EMERGENCY SHOW
EMERGENCY UPDATE
port_name The name of an Ethernet port. Available values are:
lan1, lan2, lan3 and lan4. To display the current tagged
port configured in the emergency module, use the
EMERGENCY SHOW command.
N/A
Option Description Default Value
ENABLE Set the recovery ip interface address dynamically. If no
DHCP server is available or cannot be reached, the ip
address will get an autoip address in the subnet
169.254.0.0.
N/A
DISABLE Turn off the dhcpclient on the recovery ip interface. N/A
Option Description Default Value