User guide

Emergency command reference Emergency
1-51
iMG/RG Software Reference Manual (System Configuration)
1.3.4.1.2 EMERGENCY CREATE
Syntax EMERGENCY CREATE LAN <vlan_vid>
Description This command defines a new vlan on which will be attached the ip interface used to reach
the system when running in recovery mode. Creating a new vlan requires also the defini-
tion of which Ethernet port must be tagged for this vlan. To add an Ethernet port to the
new vlan, use the EMERGENCY ADD command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
Example emergency create vlan 2
See also EMERGENCY ADD
EMERGENCY SHOW
EMERGENCY UPDATE
1.3.4.1.3 EMERGENCY DELETE
Syntax EMERGENCY DELETE VLAN <vlan_vid> [ PORT <port_name> ]
Description This command is used to delete an Ethernet port from a previously created vlan and
delete any vlan different from the default. It’s not possible delete a vlan if an Ethernet
port is assigned to this vlan as tagged port. In this case it’s necessary delete first the
Ethernet port with the command EMERGENCY DELETE VLAN PORT and then remove
the vlan with the command EMERGENCY DELETE VLAN.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
vlan_id The vlan identifier (VID) of the new vlan to be cre-
ated.
Only tagged frame with this VID will be processed
by the upper layer (IP layer) when recovery applica-
tion runs.
N/A
Option Description Default Value
vlan_id he vlan identifier (VID) of the vlan used when recov-
ery application runs.
N/A