User guide

Transports command reference Transports
8-55
iMG/RG Software Reference Manual (ADSL Port)
The same profile can be added to more than one transport.
Note: If a scheduler profile is modified after setting on this transport, the new scheduler configuration
is not applied to the transport automatically. You must enter this transport set scheduler profile
command again with the correct profile specified in order to apply changes.
Options The following table gives the range of values for each option that can be specified with
this command and a default value for each option (if applicable).
Example --> transports set eth scheduler profile p1
See also TRANSPORTS LIST
TRANSPORTS SET SCHEDULER DISABLED
QOS (chapter X-QOS)
SCHEDULER ADD PROFILE
SCHEDULER LIST PROFILES
Scheduler CLI commands
8.5.1.1.9 TRANSPORTS SET SCHEDULER DISABLED
Syntax TRANSPORTS SET {<name>|<number>} SCHEDULER DISABLED
Description This command disables packet scheduling previously set on the specified transport using
the transports set scheduler profile command. The scheduler is removed from the data
path.
Options The following table gives the range of values for each option that can be specified with
this command and a default value for each option (if applicable).
Option Description Default Value
name An existing transport. To display transport names, use
the
TRANSPORTS LIST command.
N/A
number An existing transport. To display transport numbers, use
the
TRANSPORTS LIST command.
N/A
profile name An existing profile. To display profile names, use the
SCHEDULER LIST PROFILES command.
N/A
Option Description Default Value
name An existing transport. To display transport
names, use the TRANSPORTS LIST com-
mand.
N/A