User guide

Meter command reference QOS
7-49
iMG/RG Software Reference Manual (Quality of Service)
Example --> meter set profile mp1 yellow action mark dscp 011001
See also METER LIST PROFILES
7.1.6.1.9 METER SET PROFILE ACTION PASS
Syntax METER SET PROFILE <name> {GREEN|RED|YELLOW} ACTION PASS
Description This command configures an existing profile to pass packets depending on their metering
result. The DSCP value in the IP header of packets is not set.
Note that if this command is not applied, by default the green and yellow packets are
passed and red packets are dropped.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name
An existing profile. To display names, use the METER
LIST PROFILES
command.
N/A
green Sets the DSCP value in packets with green (in profile) meter-
ing results.
N/A
red Sets the DSCP value in packets with red (out of profile)
metering results.
N/A
yellow Sets the DSCP value in packets with yellow (partially in pro-
file) metering results to be dropped.
N/A
dscp
The
Differentiated Service Code Point (DSCP). This can
be either a hexadecimal (0xNN) or a 6 binary digits
(NNNNNN), in which case the six most significant bits indi-
cate the DSCP value while the two least significant ones are
ignored.
N/A
Option Description Default Value
name
An existing profile. To display names, use the
METER
LIST PROFILES
command.
N/A
green Sets packets with green (in profile) metering results to pass. pass