User guide

Webserver Webserver command reference
iMG/RG Software Reference Manual (System Configuration)
1-42
tors the interface. The IGD can handle changes to the interface definition (for example, if
the IP address changes through a DHCP update, the IGD will use the newly assigned
address)
This command has been superseded by webserver add managementsubnets
command that extends configuration flexibility.
Example --> webserver set interface ip0
See also WEBSERVER ADD MANAGEMENTSUBNETS
1.2.3.1.9 WEBSERVER SET TELNET
Syntax WEBSERVER SET TELNET { ENABLED | DISABLED }
Description This command enable or disable the telnet service on the gateway. Once disabled, only
remote access via SSH is available.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> webserver set telnet disabled
See also WEBSERVER SHOW INFO
WEBSERVER SET TELNETSECCLASSES
1.2.3.1.10 WEBSERVER SET PORT
Syntax WEBSERVER SET PORT <PORT>
Description This command sets the HTTP port number that the Web Server process will use to
transfer data.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
ENABLED Enable telnet access to the CPE. ENABLED
DISABLED Disable totally the telnet access to the CPE. N/A
Option Description Default Value
PORT A valid port number that must be between 0 and 65535. 80