User guide

VoIP DTMF-RELAY command reference Common VoIP attributes: QoS, Media and DTMF-Relay
6-131
iMG/RG Software Reference Manual (Voice Service)
Description This command sets the number of milliseconds that a tone is locally played when a tele-
phone event rtp message is received.
The value rfc2833 is shown when telephone-event time is set 0 for communicating that the duration is man-
aged in the standard way as described in rfc2833.
Description
Options The following table gives the range of values for each option that can be speci-
fied with this command and a default value (if applicable).
Example --> voip dtmf-relay set telephone-event-time 100
See also VOIP DTMF-RELAY SHOW
See also VOIP DTMF-RELAY SHOW
6.4.7.1.4 VOIP DTMF-RELAY SET TELEPHONE-EVENT-PAYLOADTYPE
Syntax VOIP DTMF-RELAY SET TELEPHONE-PAYLOADTYPE <number>
Description This command sets the payload type advertized by iMG/RG/iBG during the call setup
when telephone-event support has been enabled.
Note: This command works only when VoIP SIP protocol is selected.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip dtmf-relay set telephone-event-payloadtype 101
See also VOIP DTMF-RELAY SHOW
6.4.7.1.5 VOIP DTMF-RELAY SHOW
Syntax VOIP DTMF-RELAY SHOW
Description This command shows the DTMF-Releay setting.
Option Description Default Value
msecs The number of milliseconds that the tome is played
when receiving a telephone event message
0
Option Description Default Value
number The payload type used inside the telephone-event
RTP message to notify DTMF tones.
default