User guide

VoIP EP command reference VoIP phone ports
6-109
iMG/RG Software Reference Manual (Voice Service)
Example --> voip ep analogue set tel1 supplementary-service-prefix *222
6.3.3.1.43 VOIP EP SET TXGAIN
Syntax VOIP EP ANALOGUE SET <name> TXGAIN <gain>
Description This command sets the output gain (in the direction from phone/user to iMG/VoIP net-
work) of the port referred to by the named access port.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set prt0 txgain –3.0
See also VOIP EP ANALOGUE CREATE
VOIP EP ANALOGUE DISABLE
VOIP EP ANALOGUE DELETE
VOIP EP ANALOGUE ENABLE
VOIP EP ANALOGUE LIST
VOIP EP ANALOGUE SHOW
Option Description Default Value
name Identifies the access port, 1 to 16 characters in length.
Valid characters are any printable characters, except
code 0x2E and 0x2F; digits cannot be used as first
character and if the space character is present, the
string must be quoted.
N/A
<digit-map> is the expression string in use to know the end of
dialling phase. Valid value is either the string is “none”
or characters like digit and symbols ‘#’, ‘*’, ‘.’, ‘|’, ‘[’,
‘]’, ‘-‘.
“none”
Option Description Default Value
name An existing access port. To display the existing
access port names, use the VOIP EP ANALOGUE
LIST command.
N/A
gain The value of rx gain in dB. Valid values are from –
48dB to +28dB.
N/A