User guide

VoIP phone ports VoIP EP command reference
iMG/RG Software Reference Manual (Voice Service)
6-100
For example: If the on-hook time is 900 msec and flash-hook time is 600msec a valid
flash-hook event must be higher than 200 msec and lower than 900 msec. If the on-hook
time is 800 msec and flash-hook time is 300msec a valid flash-hook event must be higher
than 100 msec and lower than 600 msec.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set prt0 flashhook-time 350
See also VOIP EP ANALOGUE CREATE
VOIP EP ANALOGUE DISABLE
VOIP EP ANALOGUE DELETE
VOIP EP ANALOGUE ENABLE
VOIP EP ANALOGUE LIST
VOIP EP ANALOGUE SHOW
6.3.3.1.29 VOIP EP SET HOLD-LOCAL-TONE-SERVICE
Syntax VOIP EP ANALOGUE SET <name> HOLD-LOCAL-TONE-SERVICE
{ENABLED|DISABLED}
VOIP EP DIGITAL SET <name> HOLD-LOCAL-TONE-SERVICE {ENABLED|DISA-
BLED}
Description This command enables/disables a comfort tone generated when a user is put on hold.
The generated tone has a proprietary frequency and cadence common for all countries.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Option Description Default Value
name A name that identifies an existing access port. To display the
existing access port names, use the voip ep list command.
N/A
msec The flash-hook time in millisecond. Valid values are from 80
to 600msec. Flash-hook time can not be less then the on-
hook time. Flash-hook validation window is the narrower
between msec/3 and msec*2 or msec/3 and on-hook time.
N/A
Option Description Default Value
name An existing endpoint name. -