User guide

VoIP EP command reference VoIP phone ports
6-99
iMG/RG Software Reference Manual (Voice Service)
immediately sent and this call can not be interrupted by other incoming calls using the
flash-hook key. The feature is available only on SIP protocol and must be supported by the
SIP server.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set tel1 emergency-service-number 911
6.3.3.1.27 VOIP EP SET FAX-MODEM-DETECTION
Syntax VOIP EP ANALOGUE SET <name> FAX-MODEM-DETECTION {ENABLE |
DISABLE}
Description Disables or enables detection modem and fax tones. This is enabled by default.
Example --> voip ep analogue set tel1 fax-modem-detection disable
See also VOIP EP ANALOGUE SHOW
6.3.3.1.28 VOIP EP SET FLASHHOOK-TIME
Syntax VOIP EP ANALOGUE SET <name> FLASHHOOK-TIME <msec>
Description This command set the flash-hook time on the port referred to by the named access port.
Flash-hook time cannot be less then the on-hook time. Flash-hook event is detected by
iMG when its length in msec is within a valid window. The lower limit of the window is
msec/3. The higher limit of the window is the lesser of msec*2 and the on-hook time.
Option Description Default Value
name Identifies an analogue endpoint name previously created
with the command “voip ep analogue create”.
digit-map Is the expression string in use to know the end of dialling
phase. Valid value is either the string is “none” or charac-
ters like digit and symbols ‘#’, ‘*’, ‘.’, ‘|’, ‘[’, ‘]’, ‘-‘.
“none”
Option Description Default Value
name A name that identifies an existing access port. To display the
existing access port names, use the voip ep list command.
N/A