User guide

VoIP phone ports VoIP EP command reference
iMG/RG Software Reference Manual (Voice Service)
6-96
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set prt0 dialmask 2
See also VOIP EP ANALOGUE CREATE
VOIP EP ANALOGUE DISABLE
VOIP EP ANALOGUE DELETE
VOIP EP ANALOGUE ENABLE
VOIP EP ANALOGUE LIST
VOIP EP ANALOGUE SHOW
6.3.3.1.24 VOIP EP SET DIALMODE
Syntax VOIP EP ANALOGUE SET <name> DIALMODE {AUTO | DTMF | PULSE
10PPS|20PPS}
Description This command sets the dial mode used by analogue ports. On the fxo port, if DIALM-
ODE is set to AUTO, the iMG examines the type of signalling mode supported on the
PSTN line and set the port signalling to the same mode automatically. On fxs ports, if
DIALMODE is set to AUTO, the iMG uses the same signalling mode selected for fxo
port.
If PULSE mode is selected, it's also necessary select the pulse rate: 10pps or 20pps.
Option Description Default Value
name An existing access port. To display the existing access port
names, use the VOIP EP ANALOGUE LIST command.
N/A
digit-number The number of digits to be removed from the dialled num-
ber. Acceptable values are from 0 to 3.