User guide

VoIP phone ports VoIP EP command reference
iMG/RG Software Reference Manual (Voice Service)
6-90
Example --> voip ep analogue set tel1 clip etsi
--> voip ep digital set tel clip on
See also voip ep analogue create
voip ep analogue disable
voip ep analogue delete
voip ep analogue enable
voip ep analogue list
voip ep analogue show
6.3.3.1.17 VOIP EP SET CLIP-REDUCTION
Syntax VOIP EP ANALOGUE SET <name> CLIP-REDUCTION {NONE | CC |
CC+AC}
VOIP EP ANALOGUE SET <name> CLIP-REDUCTION REPLACE <prefix-
digit> REPLACEMENT <digit>
Description This command sets the CLIP address prefix handling to be used on a previously defined
endpoint. It allows the CLIP number to be manipulated by the gateway prior to being
sent to the user handset, and is typically used to remove prefixed country-code informa-
tion so the user handset can match the delivered CLIP number with it’s internal phone
book entries.
There are four possible options:
• NONE: No CLIP prefix reduction will be performed. This is the default setting.
BELL Generate a caller ID accordingly to BELL standard. None
ETSI Generate a caller ID accordingly to ETSI standard.
The ETSI caller ID can be of two type:
DTMF: the DTMF tones can be sent before the first
ring (prior-to-ring) or after the first ring (during-ring-
ing).
FSK: the FSK signals can be sent before the first ring
(prior-to-ring) or after the first ring (during-ringing).
If not differently specified the default value is ETSI FSK
during-ringing.
NTT Generate a caller ID accordingly to NTT standard.
DTMFTDK Generate a caller ID accordingly to Denmark DTMF
standard. This setting is equal to ETSI DTMF DUR-
ING-RINGING. The value is maintained for backward
compatibility.
NONE Do not generate any caller-id