User guide

VoIP EP command reference VoIP phone ports
6-89
iMG/RG Software Reference Manual (Voice Service)
Reactivate-prefix is the prefix used to reactivate the call forwarding feature. When it is
dialed, iMG sends and INVITE containing this prefix to inform the server that the call for-
warding feature has been enabled using the same previously provisioned forward number.
The server must forwards the calls to the number previously configured with the acti-
vate-prefix. The forwarding policy (call forward on busy, call forward on no answer, etc.)
is provisioned on the server.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set tel1 enable activate-prefix *71 deactivate-prefix *72 reactivate-
prefix *73
6.3.3.1.16 VOIP EP SET CLIP
Syntax
VOIP EP ANALOGUE SET <name> CLIP {NONE | BELL | ETSI | NTT | DTMFTDK
}
VOIP EP ANALOGUE SET <name> CLIP ETSI [DTMF [DURING-RINGING |
PRIOR-TO-RINGING] | FSK [DURING-RINGING | PRIOR-TO-RINGING] ]
Description This command sets the type of caller ID that is generated during an incoming call.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Option Description Default Value
name Identifies an analogue endpoint name previously cre-
ated with the command “voip ep analogue create”.
digit-map is the expression string in use to recognize the fea-
ture. Valid characters are digit and symbols ‘#’, ‘*’, ‘.’,
‘|’, ‘[’, ‘]’, ‘-‘. The service is disabled by default.
Option Description Default Value
name A name that identifies an existing access port. To dis-
play access port names, use the VOIP EP ANALOG
LIST command.
N/A