User guide

VoIP phone ports VoIP EP command reference
iMG/RG Software Reference Manual (Voice Service)
6-86
To display the current call forwarding settings enter the VOIP EP ANALOGUE SHOW CFWD command.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set tel1 cfwd enable all-calls on-prefix *21* on-suffix # off-prefix
#21#
--> voip ep analogue set tel1 cfwd disable all-calls
6.3.3.1.13 VOIP EP SET CFWD ON-BUSY
Syntax VOIP EP ANALOGUE SET <name> CFWD ENABLE ON-BUSY ON-PREFIX
<on-prefix> ON-SUFFIX <on-suffix> OFF-PREFIX <off-prefix>
VOIP EP ANALOGUE SET <name> CFWD DISABLE ON-BUSY
Description This command enables/disables the call forwarding on busy supplementary service.
When enabled, an incoming call is automatically redirected to the forwarded number if
the called user is busy.
To enable the service the user has to enter a special code, the on-prefix code, to inform
the intelligent Multiservice Gateway that the remaining digits constitute the forwarded
number. The selection of the forwarded number terminates as soon the user enter the
on-suffix code.
To temporary disable the service, the user has to enter a special code, the off-prefix
code.
Note: The call-forwarding service is available only if the active VoIP protocol is SIP.
To display the current call forwarding settings enter the VOIP EP ANALOGUE SHOW
CFWD command.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Option Description Default Value
on-prefix The digits to dial before entering the forwarded number. N/A
on-suffix The digit (one digit only) to enter after the forwarded num-
ber has been entered via phone dialpad.
N/A
off-prefix The digits to enter after via phone dialpad to temporary dis-
able the service.
N/A