User guide

VoIP phone ports VoIP EP command reference
iMG/RG Software Reference Manual (Voice Service)
6-84
6.3.3.1.9 VOIP EP SET BLIND-CALL-TRANSFER
Syntax VOIP EP ANALOGUE SET <name> BLIND-CALL-TRANSFER ENABLE PRE-
FIX <attended_prefix>
VOIP EP ANALOGUE SET <name> BLIND-CALL-TRANSFER DISABLE
Description This command set the prefix used to activate the blind call transfer feature. The caller is
in conversation with “A”, it puts “A” on hold and calls “B” using this prefix. When “B”
answers will be in conversation with “A”.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue set tel1 blind-call-transfer enable prefix #98
6.3.3.1.10 VOIP EP SET CALL-ON-HOLD-SERVICE
Syntax VOIP EP ANALOGUE SET <name> CALL-ON-HOLD-SERVICE
{ENABLED|DISABLED}
Description This command enables/disables the call on hold supplementary service. When enabled,
the user can put the current call on hold using the flash-hook button and make a new
outgoing call. Then the user can switch between each call simply pressing the flash-hook
button.
Note: The call-on-hold service is available only if the active VoIP protocol is SIP.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Option Description Default Value
name An existing analogue endpoint name. -
attended-prefix The prefix used to enable the blind call transfer feature
only on the endpoint where it is configured.
It is a digit-map and is the expression string in use to
recognize the prefix. Valid characters are digit and sym-
bols ‘#’, ‘*’, ‘.’, ‘|’, ‘[’, ‘]’, ‘-‘, 1 to 10 characters long.
It can be configured to none
none
Option Description Default Value
name An existing analogue endpoint name. -
enabled Enable the call-on-hold service. Disabled
disabled Disable the call-on-hold service