User guide

VoIP EP command reference VoIP phone ports
6-79
iMG/RG Software Reference Manual (Voice Service)
See also VOIP EP ANALOGUE CREATE
VOIP EP ANALOGUE DISABLE
VOIP EP ANALOGUE ENABLE
VOIP EP ANALOGUE LIST
VOIP EP ANALOGUE SET
VOIP EP ANALOGUE SHOW
6.3.3.1.3 VOIP EP DIAGNOSE
Syntax VOIP EP ANALOGUE DIAGNOSE <name> {INTERNAL|EXTERNAL}
Description This command starts GR.909 metallic loop tests on the selected analogue endpoint.
The support for metallic loop tests (internal and/or external) is available only on specific
iMG families.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue diagnose tel1 internal
End point:tel1, PHY tel1 is slic port #0
Calibration:
TG 1.1865V
RG 1.1865V
TR 2.7319V
: : Pass :
Status : Test : Criteria : Results
---------------------------------------------------------------------
PASS : Battery input SWY : >=45V : 52.718V
PASS : Tip/Ground Voltage : abs <= 10V : -5.1268V
Option Description Default Value
name An existing access port. To display existing access
port names, use the VOIP EP LIST command.
N/A
internal In this case diagnostic tests apply only to internal
iMG circuitry.
N/A
external In this case diagnostic tests apply only to the exter-
nal metallic loop and resistive loads connected to
the subscriber side.
N/A