User guide

VoIP phone ports VoIP EP command reference
iMG/RG Software Reference Manual (Voice Service)
6-78
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip ep analogue create prt0 type al-fxs-del physical-port tel1
See also VOIP EP ANALOGUE DISABLE
VOIP EP ANALOGUE DELETE
VOIP EP ANALOGUE ENABLE
VOIP EP ANALOGUE LIST
VOIP EP ANALOGUE SET
VOIP EP ANALOGUE SHOW
6.3.3.1.2 VOIP EP DELETE
Syntax VOIP EP ANALOGUE DELETE <name>
Description This command deletes the named access port created previously using the VOIP EP
CREATE command.
Note: Deleting an access port where one or more users are attached, causes a deregistration procedure to be
invoked for the users attached to the removed port.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example --> voip ep analogue delete prt0
Option Description Default Value
name An arbitrary name that identifies the access port. It can
be made up of one or more letters or a combination of
letters and digits, but it cannot start with a digit. The
maximum length is fixed to 16 characters.
N/A
port-type This is the user access typology served by the physical
port; the possible values depend on the model (analog
access or digital access).Valid values are al-fxs-del, al-fxs-
lc and al-fxo-del
N/A
phy-port-id This is the physical port providing the access to VoIP
network. “Port configuration”
N/A
Option Description Default Value
name An existing access port. To display existing access port
names, use the VOIP EP LIST command.
N/A