User guide

VoIP ADMIN Command Reference VoIP phone ports
6-67
iMG/RG Software Reference Manual (Voice Service)
Note: Frequency in Hz:f1xf2 means f1 is modulated by f2
Note: f1+f2 is the juxtaposition of two frequencies f1 and f2 without modulation.
Note: Cadence in seconds:ON – OFF
6.3.1.6 Port enable/disable
It's possible to temporarily disable a port by using the VOIP EP ANALOGUE DISABLE command.
Any call originated from, or sent to, a user attached to a disabled access port is discharged.
When a port is disabled, each user added to the port starts to un-register from the Location Server (SIP signal-
ling protocol).
To change the port status from disabled to enabled use the VOIP EP ANALOGUE ENABLE command.
As soon the port is enabled all the users attached to the port automatically restart the process of registration
with the location server or gatekeeper.
To show the users attached to a port (and their SIP registration status), use the VOIP EP ANALOGUE SHOW
command.
6.3.2 VoIP ADMIN Command Reference
6.3.2.1 VoIP ADMIN commands
VoIP ADMIN commands set the service profile to be compliant with specific customer requirement and assign
main parameter concerning network administration.
Singapore 425 Continuous 425 750 - 750 425x24 400 - 200 -
400 - 2000
Spain 425 Continuous 425 200 - 200 425 1500 - 3000
Sweden 425 Continuous 425 250 - 250 425 1000 - 5000
Turkey 450 Continuous 450 500 - 500 450 2000 - 4000
United Kingdom 350+440 Continuous 400 375 - 375 400+450 400 - 200 -
400 - 2000
United States 350+440 Continuous 480+620 500 - 500 440+480 2000 - 4000
TABLE 6-12 Country-specific Telecom tones (Continued)