User guide

System command reference System Management
1-31
iMG/RG Software Reference Manual (System Configuration)
Description This command sets the system contact reported by system info command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> system contact admin@his_desk
1.1.5.1.27 SYSTEM LOCATION
Syntax SYSTEM LOCATION [<sys-location>]
Description This command sets the system location reported by system info command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> system location “Inter AT labs”
1.1.5.1.28 SYSTEM RESTART
Syntax SYSTEM RESTART
Description This command forces a warm restart on the gateway
Example --> system restart
1.1.5.1.29 SYSTEM SET LOGIN ACCESS
Syntax SYSTEM SET LOGIN <name> ACCESS {DEFAULT|ENGINEER|SUPERUSER}
Description This command sets the access permissions of a user who has been added to the system
using the SYSTEM ADD LOGIN command. Only a Super user can use this command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
SYS-CONTACT Usually a reference to some contacts. none
Option Description Default Value
SYS-LOCATION Usually a reference to the location where the sys-
tem is installed.
none