User guide

VoIP SIP User command reference VoIP SIP
6-49
iMG/RG Software Reference Manual (Voice Service)
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip sip user add MrBrown port fxs0
See also VOIP SIP USER ADD
VOIP SIP USER CREATE
VOIP SIP USER DELETE
VOIP SIP USER LIST
VOIP SIP USER REMOVE
VOIP SIP USER SHOW
VOIP EP LIST
6.2.8.1.2 VOIP SIP USER CREATE
Syntax VOIP SIP USER CREATE <username> ADDRESS <digit-map> [AREA-
CODE <area-number>] [AUTHENTICATION <login:password>]
[DOMAIN <host >] [TRANSPORT <transport>] [PSEUDONYM <pseud-
onym>]
Description This command creates a new entry in the users list. Each user must have a different
<username>. If the user already exists, an error message is raised.
This command is accepted only if the SIP module is already running. See the VOIP SIP
PROTOCOL ENABLE command to turn on the SIP module.
This command doesn’t bind the user to a physical access port. In order to inform the sys-
tem that the user is attached to a specific physical port, the VOIP SIP USER ADD com-
mand must be used.
Note: If the DOMAIN parameter is not specified, the user domain is set equal to the location server address (if
defined) or proxy server address (if location server is not defined).
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
username An existing user (it can be also the ID value associated
with the user name). To display the existing users, use the
VOIP SIP USER LIST command.
N/A
portname An existing port. To display the existing ports, use the
VOIP EP LIST command.
N/A