User guide

VoIP SIP VoIP SIP User command reference

iMG/RG Software Reference Manual (Voice Service)

6-48

6.2.8 VoIP SIP User command reference

This section describes the commands available on the iMG intelligent Multiservice Gateway to enable, configure

and manage the VoIP SIP User module.

6.2.8.1 VoIP SIP User CLI commands

The table below lists the VoIP SIP User commands provided by the CLI:

TABLE 6-8 Commands for VoIP SIP User

6.2.8.1.1 VOIP SIP USER ADD

Syntax VOIP SIP USER ADD <username> PORT <portname> [MASTER]

Description This command attaches a user created with the command VOIP SIP USER CREATE to a

named port created with the command VOIP EP ANALOGUE CREATE.

As soon as this command is entered, the registration phase starts.

Note: The system tries to register the user with the location server specified by the VOIP SIP

LOCATIONSERVER CREATE command. If no location servers are defined, the system tries to register

the user with the proxy server specified by the VOIP SIP PROXYSERVER CREATE command. If no

proxy servers are defined, registration phase is not performed until a location server or proxy server is

added to the SIP module.

To display the user's registration status and port association use the VOIP SIP USER

SHOW command.

The optional ‘master’ token may be used when multiple users are added to a single port.

Marking a user as ‘master’ indicates that this user should be specified in the From header

of outgoing SIP INVITE requests. Note that is no user is marked as ‘master’, then the

address of last user added to the port will be used in the From header of outgoing SIP

INVITE requests.

Commands

Fiber

E Modular

ADSL

VOIP SIP USER ADD XXXXX X XXX

VOIP SIP USER CREATE XXXXX X XXX

VOIP SIP USER DELETE XXXXX X XXX

VOIP SIP USER LIST XXXXX X XXX

VOIP SIP USER REMOVE XXXXX X XXX

VOIP SIP USER SHOW XXXXX X XXX