User guide

VoIP SIP VoIP SIP Embeddedserver command reference
iMG/RG Software Reference Manual (Voice Service)
6-44
6.2.7 VoIP SIP Embeddedserver command reference
This section describes the commands available on the AT-iBG900 intelligent Multiservice Gateway to enable,
configure and manage the VoIP SIP Embeddedserver module.
6.2.7.1 VoIP SIP Embeddedserver CLI commands
The table below lists the VOIP SIP Embeddedserver commands provided by the CLI:
TABLE 6-7 Commands for VoIP Embeddedserver
6.2.7.1.1 VOIP SIP EMBEDDEDSERVER CREATE
Syntax VOIP SIP EMBEDDEDSERVER CREATE <name> [DOMAIN <domain>] CON-
TACT <host:port/transport >
Description This command creates a new entry in the embedded servers’ list. If the embedded server
already exists, an error message is raised. Currently only one embedded server can be
configured
This command is accepted only if the SIP module is already running. See the VOIP SIP
PROTOCOL ENABLE command to turn on the SIP module.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Commands
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E Modular
ADSL
A
ADSL
B
ADSL
C
VOIP SIP EMBEDDEDSERVER CREATE XXX X X X X
VOIP SIP EMBEDDEDSERVER DELETE XXX X X X X
VOIP SIP EMBEDDEDSERVER LIST XXX X X X X
VOIP SIP EMBEDDEDSERVER SET EMERGENCY-SERVICE XXX X X X X
VOIP SIP EMBEDDEDSERVER SET PERMANENT-STORAGE XXX X X X X
VOIP SIP EMBEDDEDSERVER SHOW XXX X X X X
Option Description Default Value
name An arbitrary name that identifies the embedded server.
The name must not be present already. The name can
be at most 16 characters long; cannot start with a digit
and cannot contain dots '.' or slash symbols '/'.
N/A