User guide

VoIP SIP Proxyserver command reference VoIP SIP
6-41
iMG/RG Software Reference Manual (Voice Service)
6.2.6 VoIP SIP Proxyserver command reference
This section describes the commands available on the iMG intelligent Multiservice Gateway to enable, configure
and manage the VoIP SIP Proxyserver module.
6.2.6.1 VoIP SIP Proxyserver CLI commands
The table below lists the VOIP SIP Proxyserver commands provided by the CLI:
TABLE 6-6 Commands for VoIP Proxy Server
6.2.6.1.1 VOIP SIP PROXYSERVER CREATE
Syntax
VOIP SIP PROXYSERVER CREATE <name> CONTACT <host:port/transport >
Description This command creates a new entry in the proxy servers’ list. Each proxy server must
have a different <name>. If the proxy server already exists, an error message is raised.
This command is accepted only if the SIP module is already running. See the VOIP SIP
PROTOCOL ENABLE command to turn on the SIP module.
This command doesn’t set the master proxy server. To define a proxy server as master
use the VOIP SIP PROXYSERVER SET MASTER command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Commands
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E
Modular
ADSL
A
ADSL
B
ADSL
C
VOIP SIP PROXYSERVER CREATE XXXXX X X X X
VOIP SIP PROXYSERVER DELETE XXXXX X X X X
VOIP SIP PROXYSERVER LIST XXXXX X X X X
VOIP SIP PROXYSERVER SET MASTER XXXXX X X X X
Option Description Default Value
name An arbitrary name that identifies the proxy server. The
name must not be present already.The name can be at
most 16 characters long; cannot start with a digit and
cannot contain dots '.' or slash symbols '/'.
N/A
host The hostname or IPv4 address of the proxy server
where signalling messages are senthost can be at most
256 chars long (when using hostname format).
N/A