User guide

VoIP SIP VoIP SIP Locationserver command reference

iMG/RG Software Reference Manual (Voice Service)

6-38

TABLE 6-5 VoIP SIP Location Server CLI Commands

6.2.5.1.1 VOIP SIP LOCATIONSERVER CREATE

Syntax

VOIP SIP LOCATIONSERVER CREATE <name> CONTACT <host:port/transport

Description This command creates a new entry in the location server list. Each location server must

have a different <name>. If the location server already exists, an error message is raised.

This command is accepted only if the SIP module is already running. See the VOIP SIP

PROTOCOL ENABLE command to turn on the SIP module.

This command doesn’t set the master location server. To define a location server as mas-

ter use the VOIP SIP LOCATIONSERVER SET MASTER command.

Options The following table gives the range of values for each option that can be specified with

this command and a default value (if applicable).

Commands

Fiber

E Modular

ADSL

VOIP SIP LOCATIONSERVER CREATE XXXXX X XXX

VOIP SIP LOCATIONSERVER DELETE XXXXX X XXX

VOIP SIP LOCATIONSERVER LIST XXXXX X XXX

VOIP SIP LOCATIONSERVER SET MASTER XXXXX X XXX

Option Description Default Value

name An arbitrary name that identifies the location server. The

name must not be present already. The name can be at most

16 characters long; cannot start with a digit and cannot con-

tain dots '.' or slash symbols '/'.

N/A

host The hostname or IPv4 address of the location server where

registrations are sent.

host can be at most 256 chars long (when using hostname

format).

N/A

port The UDP/TCP port on the location server to which signalling

messages are sent.

5060