User guide

VoIP SIP Locationserver command reference VoIP SIP
6-37
iMG/RG Software Reference Manual (Voice Service)
Server redundancy: permanent
Server switching: on link failure only
Remote Party ID replacement
on call-forwarding: disabled
Contact header on 1xx response: disabled
Event Subscription message-summary: disabled
INFO signal mapping:
DTMF_
0 Signal=0
DTMF_1 Signal=1
DTMF_2 Signal=2
DTMF_3 Signal=3
DTMF_4 Signal=4
DTMF_5 Signal=5
DTMF_6 Signal=6
DTMF_7 Signal=7
DTMF_8 Signal=8
DTMF_9 Signal=9
DTMF_Star Signal=*
DTMF_Gate Signal=#
DTMF_A Signal=A
DTMF_B Signal=B
DTMF_C Signal=C
DTMF_D Signal=D
Flash
-->
See also VOIP SIP PROTOCOL ENABLE
VOIP SIP PROTOCOL SET MEDIAPORT
VOIP SIP PROTOCOL SET EXTENSION
6.2.5 VoIP SIP Locationserver command reference
This section describes the commands available on the iMG intelligent Multiservice Gateway to enable, configure
and manage the VoIP SIP Locationserver module.
6.2.5.1 VoIP SIP Locationserver CLI commands
The table below lists the VOIP SIP Locationserver commands provided by the CLI: