User guide

VoIP SIP VoIP SIP command reference
iMG/RG Software Reference Manual (Voice Service)
6-36
Description By default iMG use his IP address Uri host part of the sent SIP messages. This command
allows to configure the URI host part. The possible choices are listed in the following
table.
Example --> voip sip protocol set URIhost system-name
See also VOIP SIP PROTOCOL SHOW
6.2.4.1.25 VOIP SIP PROTOCOL SHOW
Syntax VOIP SIP PROTOCOL SHOW
Description This command displays basic SIP module configuration parameters set by the VOIP SIP
PROTOCOL SET commands.
Example --> voip sip protocol show
--> voip sip protocol show
Gateway base protocol: SIP
--------------------------------------------------------------------
Network interface: ip0
Default port: 5060
NAT:
Extension features: none
Unreserved chars: none
Dialog authentication method: proxy
SIP URI host scheme: local-ip
Keep alive disabled (300 secs.)
Round-trip time: 500 msecs.
Registration/Subscription retry time: 20 secs.
Registration ring splash: disabled
Invite transaction timeout: 32 secs. (6 retransmition
times)
Session expire time: 1800 secs.
Internal call routing: enabled
Option Description
LOCAL-IP The URI host is the IP address of the IP interface where the SIP is
attached.
DNS-HOSTNAME iMG resolves its DNS-HOSTNAME and uses it as URI host. If the
address resolution fails, the LOCAL-IP is used.
SYSTEM-NAME iMG uses the SYSTEM-NAME configured on the device via CLI com-
mand SYSTEM NAME as URI host. If the SYSTEM NAME is not config-
ured, the LOCAL-IP is used as URI host.