User guide

System Management System command reference
iMG/RG Software Reference Manual (System Configuration)
1-28
The RIP and IP modules provide separate categories that are enabled and disabled inde-
pendently. For example, if you enable IP RAWIP, it does not affect IP UDP, and so on.
To display a list of modules and categories and their enable/disable status, see SYSTEM
LOG LIST.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> system log enable rip rx
enabled logging for the receiving of RIP packets
See also SYSTEM LOG LIST
SYSTEM LOG
1.1.5.1.24 SYSTEM LOG LIST
Syntax SYSTEM LOG LIST [<module>]
Description The system log list command displays the tracing options for the modules available in the
current image that you are using. The SYSTEM LOG LIST MODULE command displays
the tracing options for an individual module specified in the command. Both commands
display the current status of the tracing options set using the command SYSTEM LOG
ENABLE|DISABLE.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> system log list
--> sys log list
ip arp (disabled)
Option Description Default Value
ENABLE Enables tracing support output for a specified specific
module and module category.
Disable
DISABLE Disables tracing support output for a specified spe-
cific module and module category.
Disable
Option Description Default Value
MODULE The name of a module that exists in your current
image build. This can be either RIP or IP.
N/A