User guide

VoIP SIP command reference VoIP SIP
6-35
iMG/RG Software Reference Manual (Voice Service)
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip sip protocol set sessionexpire 180
See also VOIP SIP PROTOCOL SHOW
6.2.4.1.22 VOIP SIP PROTOCOL SET SUBSCRIBE-EVENT-MESSAGE-SUMMARY
Syntax VOIP SIP PROTOCOL SET SUBSCRIBE-EVENT-MESSAGE-SUMMARY
{ENABLED | DISABLED}
Description This command enables and disables subscription to SIP message summary events.
Note: This command can only be used prior to creating any SIP users on the gateway.
The default value is disabled.
Example --> voip sip protocol set subscribe-event-message-summary enabled
See also VOIP SIP PROTOCOL SHOW
VOIP SIP USER CREATE
6.2.4.1.23 VOIP SIP PROTOCOL SET UNRESERVED-CHAR-EXTENSION
Syntax VOIP SIP PROTOCOL SET UNRESERVED-CHAR-EXTENTION {NONE | #}
Description SIP protocol states the char “#” must not be present in SIP messages and it must be
replaced with “%23” (23 is the ASCII value for “#”). This command allows leaving the
char # in the SIP message to accommodate some SIP implementation and easy fix possi-
ble interoperability issues.
Example --> voip sip protocol set unreserved-char-extension #
See also VOIP SIP PROTOCOL SHOW
6.2.4.1.24 VOIP SIP PROTOCOL SET URIHOST
Syntax
VOIP SIP PROTOCOL SET URIHOST {DNS-HOSTNAME | LOCAL-IP | SYSTEM-NAME}
Option Description Default Value
secs The session expire time in seconds. Available val-
ues are in the range 30 to 86400 sec (24 hours).
1800