User guide

VoIP SIP command reference VoIP SIP
6-31
iMG/RG Software Reference Manual (Voice Service)
Example --> voip sip protocol set nat address iMG.voip.atkk.com
--> voip sip protocol set nat interface ip0
See also IP LIST INTERFACES
VOIP SIP PROTOCOL ENABLE
VOIP SIP PROTOCOL SHOW
6.2.4.1.13 VOIP SIP PROTOCOL SET NETINTERFACE
Syntax VOIP SIP PROTOCOL SET NETINTERFACE <interface_name>
Description This command sets the IP interface used to access the VoIP network.
Signalling and voice packets will use the Source IP address defined for the selected inter-
face.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip sip protocol set netinterface ip0
See also VOIP SIP PROTOCOL ENABLE
6.2.4.1.14 VOIP SIP PROTOCOL SET PATH-HEADER
Syntax VOIP SIP PROTOCOL SET PATH-HEADER {ENABLE|DISABLE|PROFILE}
Description This command includes the PATH-HEADER support on REGISTER messages as detailed
by RFC 3327 to discovering intermediate proxies during SIP registration.
By default the path-header support is tied to the SIP profile defined at admin level. If the
SIP profile requests the path-header support, then the support is automatically turned on,
otherwise it is left off.
It’s also possible to force the path-header to be always turned off or on independently
from the profile selected.
When path-header support is enabled and the iMG receives a valid path-header value a
response to the REGISTER request, all the subsequent outgoing calls will use the address
specified by the path-header value as outgoing proxy.
Option Description Default Value
interface_name An existing IP interface. To display interface
names, use the IP LIST INTERFACES command.
N/A