User guide

VoIP SIP command reference VoIP SIP
6-29
iMG/RG Software Reference Manual (Voice Service)
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip sip protocol set info DTMF_0 Signal=0
See also VOIP SIP PROTOCOL SHOW
6.2.4.1.9 VOIP SIP PROTOCOL SET INTERNAL-CALL-ROUTING
Syntax
VOIP SIP PROTOCOL SET INTERNAL-CALL-ROUTING {ENABLE | DISABLE}
Description This command enables/disables the internal-call-routing feature. By default, if more than
one SIP user has been created on the iMG device, a call between two of them does not
contact the configured SIP proxy server. By setting internal-call-routing to disable, the
device always contacts the SIP proxy server.
Example --> voip sip protocol set internal-call-routing disable
See also VOIP SIP PROTOCOL ENABLE
6.2.4.1.10 VOIP SIP PROTOCOL SET INVITETIMEOUT
Syntax VOIP SIP PROTOCOL SET INVITETIMEOUT <sec>
Description This command sets the number of seconds an INVITE that does not receive any answer
must be sent. During an outgoing call, the INVITE sent by iMG must be received an
answer within ROUNDTRIPTIME msec. If the answer is not received, the same INVITE is
re-transmitted and the ROUNDTRIPTIME’s value is doubled. This process ends INVITE-
TIMEOUT seconds after the first INVITE.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
token
Signal element to be used for the DTMF
digit of flash-hook event. These should take
the form ‘Signal=x’, where x is one of the
digits 0-9, *, #, A, B, C, or D.
N/A
Option Description Default Value
sec Number of seconds that an INVITE with no
answer must be sent.
32