User guide

VoIP SIP VoIP SIP command reference
iMG/RG Software Reference Manual (Voice Service)
6-26
Syntax VOIP SIP PROTOCOL DISABLE
Description This command stops the VoIP SIP signalling protocol and releases all the resources asso-
ciated to it:
• Any analogue or digital port defined in the system is removed
• Any user defined in the system is deleted
• Any forwarding entry in the FDB is deleted
• Any sip server reference (location and proxy) is removed
To simply restart the SIP module, use the VOIP SIP PROTOCOL RESTART command. It
doesn't remove any resources defined under the VoIP main module.
To enable the SIP module, use the VOIP SIP PROTOCOL ENABLE command.
Example --> voip sip protocol disable
See also VOIP SIP PROTOCOL RESTART
VOIP SIP PROTOCOL ENABLE
6.2.4.1.2 VOIP SIP PROTOCOL ENABLE
Syntax VOIP SIP PROTOCOL ENABLE
Description This command turns on the SIP signalling module.
To bind the SIP module to a specific IP interface use the VOIP SIP PROTOCOL SET
INTERFACE command.
Note: Binding the SIP module to a specific IP interface defines the value of the source IP address for signalling
and voice packets. SIP URLs with local reference offer the hostname and the IP address belonging the
provisioned interface.
Note: The SIP module MUST be enabled in order to create/set analog/digital ports, users, call forwarding rules
and SIP servers.
Example --> voip sip protocol enable
See also VOIP SIP PROTOCOL SHOW
VOIP SIP PROTOCOL DISABLE
6.2.4.1.3 VOIP SIP PROTOCOL RESTART
Syntax VOIP SIP PROTOCOL RESTART
Description This command restarts the VoIP SIP signalling protocol module.
Any pending and active calls are released.