User guide

VoIP MGCP VOIP MGCP command reference
iMG/RG Software Reference Manual (Voice Service)
6-14
HeartBeat Refresh Time: 15
Round-trip time: 10000 msecs.
Maximum re-transmition time: 30 secs.
Network loss rate: 0 %
TEL1 Syntax Name: aaln/0@[$IP]
TEL2 Syntax Name: aaln/1@[$IP]
Example -> voip mgcp protocol show tel1
Gateway base protocol: MGCP end-point tel1
---------------------------------------------------------
Operational state: Normal
Notified call-agent: None
Digit-map: (default) x.T
(current) x
See also VOIP MGCP PROTOCOL ENABLE
6.1.7.2.9 VOIP MGCP CALLAGENT CREATE
Syntax OIP MGCP CALLAGENT CREATE <name> CONTACT <host>
Description This command set the call agent address. More than one call agent can be defined to
increase system robustness in case of server failure.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip mgcp callagent create default contact 192.168.102.3
See also VOIP MGCP CALLAGENT LIST
VOIP MGCP CALLAGENT DELETE
Option Description Default Value
name An arbitrary name that identifies the call agent. The
name must not be present already. The name can be a
maximum of 16 characters long; cannot start with a digit
and cannot contain dots '.' or slash symbols '/'.
N/A
host The hostname or IPv4 address of the call agent. Host can
be a maximum of 256 chars long (when using hostname
format).
N/A