User guide

VOIP MGCP command reference VoIP MGCP
6-11
iMG/RG Software Reference Manual (Voice Service)
6.1.7.2.2 VOIP MGCP PROTOCOL SET NAT
Syntax VOIP MGCP PROTOCOL SET NAT {NONE | <host>}
Description This command sets the NAT host reference. Any MGCP message with local reference is
hidden by the NAT address value.
Changing the NAT reference causes the MGCP module to restart.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip mgcp protocol set nat 10.17.90.110
Example --> voip mgcp protocol set nat at-img600.voip.atkk.com
See also VOIP MGCP PROTOCOL ENABLE
6.1.7.2.3 VOIP MGCP PROTOCOL SET NETINTERFACE
Syntax VOIP MGCP PROTOCOL SET NETINTERFACE <interface_name>
Description This command sets the IP interface used to access the VoIP network.
Signaling and voice packets will use the Source IP address defined for the selected inter-
face.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip MGCP protocol set netinterface ip0
See also VOIP MGCP PROTOCOL ENABLE
6.1.7.2.4 VOIP MGCP PROTOCOL SET PIGGYBACK
Syntax VOIP MGCP PROTOCOL SET PIGGYBACK {ENABLE|DISABLE}
Option Description Default Value
host The address that must displayed in the MGCP messages. It
can be expressed in hostname format or IPv4 format. A
Hostname can be a maximum of 255 characters long.
None
Option Description Default Value
interface_name An existing IP interface. To display interface names, use
the IP LIST INTERFACES command.
N/A