User guide

VoIP MGCP VOIP MGCP command reference

iMG/RG Software Reference Manual (Voice Service)

6-10

Example --> voip mgcp prot set endpoint-syntax aaln/0@[$IP] port tel1

The endpoint identifier is: aaln/0@[10.17.90.135]

Example --> voip mgcp prot set endpoint-syntax $MAC:aaln/0@[$IP]

port tel1

The endpoint identifier is: 102030405061:aaln/0@[10.17.90.135]

Example --> voip mgcp prot set endpoint-syntax $MAC:aaln/1@[$HOST]

port tel2

The endpoint identifier is: 102030405061:aaln/1@[gatewat-90-135]

Example --> voip mgcp prot set endpoint-syntax tel3@[$HOST] port tel3

The endpoint identifier is: tel3@[gatewat-90-135]

Example --> voip mgcp prot set endpoint-syntax aaln/0@$IP port tel1

The endpoint identifier is: aaln/0@10.17.90.135

6.1.7.2.1 VOIP MGCP PROTOCOL SET HEARTBEAT

Syntax VOIP MGCP PROTOCOL SET HEARTBEAT {ENABLE|DISABLE}

Description This command enables/disables the heartbeat feature. The heartbeat consists on a

MGCP message periodically sent by the gateway to inform the callagent that the end

points are up and running. The heartbeat is implemented only under some specific

MGCP profiles and the sent heartbeat message is different for each profile. The following

table lists the profiles and heartbeat messages.

Example --> voip mgcp protocol set heartbeat enable