User guide

VOIP MGCP command reference VoIP MGCP
6-9
iMG/RG Software Reference Manual (Voice Service)
TABLE 6-3 Possible Combinations for MGCP Profile
If system name is not set and/or it is not configured by DHCP, $HOST variable must be replaced by the IP
address.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example Suppose to have a device with the following parameter values:
IP Address=10.17.90.135
MAC Address=10:20:30:40:50:61
System name=gatewat-90-135
TBD TBD
NONE, AGS, GB and SIEMENS aaln/0@[$IP] for endpoint tel1
aaln/1@[$IP] for endpoint tel2
aaln/2@[$IP] for endpoint tel3
aaln/3@[$IP] for endpoint tel4
MARCONI aaln/1@[$IP] for endpoint tel1
aaln/2@[$IP] for endpoint tel2
aaln/3@[$IP] for endpoint tel3
aaln/4@[$IP] for endpoint tel4
SPHERE $MAC:aaln/0@[$IP] for endpoint tel1
$MAC:aaln/1@[$IP] for endpoint tel2
$MAC:aaln/2@[$IP] for endpoint tel3
$MAC:aaln/3@[$IP] for endpoint tel4
CISCOBTS aaln/0@$IP for endpoint tel1
aaln/1@$IP for endpoint tel2
aaln/2@$IP for endpoint tel3
aaln/3@$IP for endpoint tel4
Option Description Default Value
ep-syntax It is the endpoint identifier used by the gateway
and by the Call Agent in the command messages.
-