User guide

VoIP MGCP VOIP MGCP command reference
iMG/RG Software Reference Manual (Voice Service)
6-8
6.1.7.2 VOIP MGCP PROTOCOL SET ENDPOINT-SYNTAX
Syntax VOIP MGCP PROTOCOL SET ENDPOINT-SYNTAX <ep-syntax> port
<portname>
Description This command allows to customize the endpoint identifier (EPID) used inside MGCP
messages. The endpoint identifier syntax can be created using some variables listed in the
following table:
The endpoint identifier syntax default value depends on the used MGCP profile. The following table lists all the
combinations.
Variable Description
TBD TBD
$IP It will be replaced with the gateway’s IP Address
$MAC It will be replaced with the gateway’s MAC Address
$HOST It will be replaced with the gateway’s System name
(If the system name is not configured the IP address will be used).