User guide

VOIP MGCP command reference VoIP MGCP
6-7
iMG/RG Software Reference Manual (Voice Service)
Description --> voip mgcp protocol enable
See also VOIP MGCP PROTOCOL SHOW
VOIP MGCP PROTOCOL DISABLE
6.1.7.1.3 VOIP MGCP PROTOCOL RESTART
Syntax VOIP MGCP PROTOCOL RESTART
Description This command restarts the VoIP MGCP signaling protocol module.
Any pending and active calls are released.
This command doesn't release any resources previously created during module configura-
tion.
Example --> voip mgcp protocol restart
See also VOIP MGCP PROTOCOL ENABLE
6.1.7.1.4 VOIP MGCP PROTOCOL SET DEFAULTPORT
Syntax VOIP MGCP PROTOCOL SET DEFAULTPORT <ipport>
Description This command sets the default listening/sending port used for MGCP signaling messages.
By default, when the MGCP module is attached to an IP interface using the VOIP MGCP
PROTOCOL SET NETINTERFACE command, the following default value is used:
defaultport:2427
Changing the signaling port causes the MGCP module to restart.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> voip mgcp protocol set defaultport 2427
See also VOIP MGCP PROTOCOL ENABLE
Option Description Default Value
ipport UDP/TCP port number used for signalling mes-
sages. Available values are in the range 1026 to
65534. Only even values can be accepted
2427