User guide

VoIP MGCP VOIP MGCP command reference
iMG/RG Software Reference Manual (Voice Service)
6-6
6.1.7.1.1 VOIP MGCP PROTOCOL DISABLE
Syntax VOIP MGCP PROTOCOL DISABLE
Description This command stops the VoIP MGCP signalling protocol and releases all the resources
associated to it.
This command is typically used when it's necessary to change the VoIP signalling proto-
col, i.e. from MGCP to SIP.
To simply restart the MGCP module, use the VOIP MGCP PROTOCOL RESTART com-
mand. It doesn't remove any resources defined for the protocol.
To enable the MGCP module, use the VOIP MGCP PROTOCOL ENABLE command.
Example --> voip mgcp protocol disable
See also VOIP MGCP PROTOCOL RESTART
VOIP MGCP PROTOCOL ENABLE
6.1.7.1.2 VOIP MGCP PROTOCOL ENABLE
Syntax VOIP MGCP PROTOCOL ENABLE
Description This command turns on the MGCP signaling module.
To bind the MGCP module to a specific IP interface use the VOIP MGCP PROTOCOL
SET NETINTERFACE command.
Binding the MGCP module to a specific IP interface defines the value of the source IP
address for signalling and voice packets.
VOIP MGCP PROTOCOL SET ROUNDTRIPTIME XXXXX X XXX
VOIP MGCP PROTOCOL SHOW XXXXX X XXX
VOIP MGCP CALLAGENT CREATE XXXXX X XXX
VOIP MGCP CALLAGENT SET MASTER XXXXX X XXX
VOIP MGCP CALLAGENT DELETE XXXXX X XXX
VOIP MGCP CALLAGENT LIST XXXXX X XXX
TABLE 6-2
VoIP MGCP commands (Continued)
Functions
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E Modular
ADSL
A
ADSL
B
ADSL
C