User guide

SNTP SNTP command reference
iMG/RG Software Reference Manual (System Administration)
5-102
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> sntpclient set pollintv 10
5.3.3.1.9 SNTPCLIENT SYNC
Syntax SNTPCLIENT SYNC
Description This command forces the SNTP client to immediately synchronize the local time with the
server located in the association list (if unicast) or, if anycast is enabled, initiate an anycast
sequence to the network.
Example --> sntpclient sync
See also SNTPCLIENT ADD SERVER
5.3.3.1.10 SNTPCLIENT SET TIMEOUT
Syntax SNTPCLIENT SET TIMEOUT <timeout>
Description This command sets the received packet response timeout value (in seconds) upon sync
request initiation. After timeout, if the SNTPCLIENT RETRY command value is set, an
attempt will be retried.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> sntpclient set timeout 10
See also SNTPCLIENT SET RETRIES
Option Description Default Value
pollintv Sets the polling interval (in minutes) that SNTP client will
sync with a designated server. This can be any value between
0 and 30.
0 (disabled)
Option Description Default Value
timeout Sets the received packet response timeout value (in sec-
onds). This can be any value between 0 and 30.
5 seconds