User guide

Dynamic Host Configuration Protocol DHCP Client command reference
iMG/RG Software Reference Manual (System Administration)
5-70
Example --> dhcpclient set interfaceconfig client1 dhcpinform disabled
See also DHCPCLIENT LIST INTERFACECONFIGS
DHCPCLIENT SET INTERFACECONFIG SERVER
5.1.6.1.19 DHCPCLIENT SET INTERFACECONFIG DHCPSERVERPOOLSIZE
Syntax DHCPCLIENT SET INTERFACECONFIG {<name>|<number>} DHCPSERVER-
POOLSIZE <pool size>
Description This command tells DHCP client to configure a DHCP server on the LAN if the given
address pool size is set to a number greater than 0. The LAN DHCP server is configured
using parameters received by a DHCP client interface on the WAN. Information such as
DNS server addresses can then be distributed to LAN clients. The new DHCP server
gives out the default gateway address as its LAN IP address.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
number An existing DHCP client interface. To display client
interface numbers, use the DHCPCLIENT LIST
INTERFACECONFIGS
command.
N/A
enabled Enables the dhcpinform message type. IP address
and subnet mask will not be negotiated if this mode
is selected.
disabled
disabled Disables the dhcpinform message type.
Option Description Default Value
name An existing DHCP client interface. To display cli-
ent interface names, use the
DHCPCLIENT
LIST INTERFACECONFIGS
command.
N/A
number An existing DHCP client interface. To display cli-
ent interface numbers, use the DHCPCLI-
ENT LIST INTERFACECONFIGS
command.
N/A
pool size The number of DHCP client addresses in a pool.
The first address in the pool is the address
immediately after the LAN DHCP address. For
example, if the LAN DHCP address is
192.168.102.3, the first address in the pool will
be 192.168.102.4.
N/A