User guide

DHCP Client command reference Dynamic Host Configuration Protocol
5-69
iMG/RG Software Reference Manual (System Administration)
Example --> dhcpclient set interfaceconfig client1 defaultroute disabled
See also DHCPCLIENT LIST INTERFACECONFIGS
5.1.6.1.18 DHCPCLIENT SET INTERFACECONFIG DHCPINFORM ENABLED|DISABLED
Syntax DHCPCLIENT SET INTERFACECONFIG {<name>|<number>} DHCPINFORM
{ENABLED|DISABLED}
Description This command enables/disables whether DHCP client uses the dhcpinform message
type. This DHCP message type is used whenever a client has obtained an IP address or
subnet mask (for example, the address has been manually configured or obtained through
PPP/IPCP), but wishes to obtain extra configuration parameters (such as DNS servers or
default gateway) from a DHCP server.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing DHCP client interface. To display cli-
ent interface names, use the
DHCPCLIENT
LIST INTERFACECONFIGS
command.
N/A
number An existing DHCP client interface. To display cli-
ent interface numbers, use the DHCPCLIENT
LIST INTERFACECONFIGS
command.
N/A
enabled DHCP client uses default gateway information it
receives from DHCP server.
enabled
disabled DHCP client does not use default gateway infor-
mation it receives from DHCP server.
Option Description Default Value
name An existing DHCP client interface. To display client
interface names, use the
DHCPCLIENT LIST
INTERFACECONFIGS
command.
N/A