User guide

Dynamic Host Configuration Protocol DHCP Server command reference
iMG/RG Software Reference Manual (System Administration)
5-36
Example --> dhcpserver subnet sub1 add option auto-configure 1
See also DHCPCLIENT SET INTERFACECONFIG AUTOIP ENABLED|DISABLED
Note: For a list of options that you can choose from, see DHCPSERVER LIST OPTIONS
For information on RFC 2132, see http://www.ietf.org/rfc/rfc2132.txt
5.1.5.1.50 DHCPSERVER SUBNET ADD POOL
Syntax DHCPSERVER SUBNET <name> ADD POOL <poolname> <startaddr>
<endaddr>
Description This command allows you to configure the DHCP server adding a pool to the specified
subnet
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> dhcpserver subnet sub1 add pool mypool 10.17.90.1 10.17.90.128
5.1.5.1.51 DHCPSERVER SUBNET CLEAR IPRANGES
Syntax DHCPSERVER SUBNET {<name>|<number>} CLEAR IPRANGES
Description This command deletes all of the IP ranges set for an existing subnet.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
number An existing subnet. To display subnet numbers, use the
DHCPSERVER LIST SUBNETS command.
N/A
identifier A text string that identifies a DHCP server configuration
option.
N/A
value The value associated with the option identifier. N/A
Option Description Default Value
name the name of the subnet N/A
poolname Name of the pool to be added N/A
startaddr Starting IP address for the Pool IP range N/A
endaddr Ending IP address for the Pool IP range N/A