User guide

NAT command reference Network address translation - NAT
4-145
iMG/RG Software Reference Manual (IPNetwork Functions)
Example --> nat list globalpools extinterface
NAT global address pool:
ID | Name | Type | Subnet | IP address | Mask/End Address
--------------------------------------------------------------------
1 | gp1 | dmz | true | 192.168.102.3 | 255.255.255.0
2 | g2 | internal | false | 192.168.103.2 | 192.168.103.50
--------------------------------------------------------------------
See also SECURITY LIST INTERFACES
NAT SHOW GLOBALPOOL
4.4.5.1.8 NAT SHOW GLOBALPOOL
Syntax NAT SHOW GLOBALPOOL <name> <interfacename>
Description This command displays information about a single network address pool that has been
added to an outside interface:
• Type of inside interface (internal or DMZ)
• Subnet configuration status (true if the network pool was set using a subnet mask,
false if it was set using a range of IP addresses)
• IP address - the outside network IP address or the first address in the range of
addresses
• Subnet Mask or End Address - the subnet mask of the outside network IP address or
the last address in the range of addresses
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Option Description Default Value
interface-
name
The name of an existing security interface (external or
DMZ) created and connected to an inside interface (DMZ
or internal) using the NAT ENABLE command. To display
security interfaces, use the SECURITY LIST INTERFACES
command.
N/A