User guide

Security Security command reference
iMG/RG Software Reference Manual (IPNetwork Functions)
4-96
Protocol: 17
Local Real Port: 4000
Local Mapping Port: 500
Remote Port: 65535
Duration: 300
Reusable: true
Enabled: true
Description: whatisit
4.2.7.1.42 SECURITY ENABLE|DISABLE IDS
Syntax SECURITY {enable | disable} IDS
Description This command explicitly enables/disables IDS (Intrusion Detection Service). You must
enable IDS if you want to activate the settings specified in the security IDS commands.
If you disable IDS during a session, any configuration changes made when IDS was
enabled are not deleted - you can re-enable them later in the session.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example --> security enable IDS
See also SECURITY enable|disable
4.2.7.1.43 SECURITY ENABLE|DISABLE IDS BLACKLIST
Syntax security enable|disable IDS blacklist
Description This command enables support for the IDS blacklist (Intrusion Detection Setting). Black-
listing denies an external host access to the system if IDS has detected an intrusion from
that host. Access to the network is denied for ten minutes.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Option Description Default Value
enable Enables the IDS portion of the Security module. Disable
disable Disables the IDS portion of the Security module.
Option Description Default Value
enable Enables blacklisting of an external host if IDS has
detected an intrusion from that host..
Disable