User guide

Security Security command reference
iMG/RG Software Reference Manual (IPNetwork Functions)
4-92
4.2.7.1.36 SECURITY SET SESSIONTIMEOUT
Syntax security set session tiemout {esp | icmp | other | tcpclose
| tcpestb | tcpinit | udp} <duration>
Description This command enables user to configure a time out period after which any session may
timeout.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example --> security set session timeout icmp 20
4.2.7.1.37 SECURITY ADD WAITINGSESSION
Syntax SECURITY ADD WAITINGSESSION <name> <interface>
<local_real_ip> <tranport_type> <local_mapping_port>
<local_real_port> [<idle_timeout> {enabled | disabled}
COMMENT <comment> REMOTEIP <remoteip>]
Description This command adds a waitingsession to the security module. Waiting sessions are a sort
of “presessions” which are created so that the security modules know about the
expected traffic.
A waiting session must at least have specific local and mapping IP addresses defined. The
other parameters (IP addresses, protocol, port numbers) may be specified as wildcards.
However, the more parameters specified, the more secure the waiting session.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Option Description Default Value
duration Time period configured by user for session time out.. N/A
Option Description Default Value
name Name of the waitingsession N/A
interface Specify the external/dmz interface over which traffic
is expected
N/A
local_real_ip Specify the IP address of the local host which is
expecting this traffic
N/A
transport_type Specify the transport type for the traffic eg. TCP/
UDP
N/A